Petsafe Drinkwell Mini Manual do Utilizador descarregar pdf (Página 68)

www.petsafe.net

FOUNTAIN REASSEMBLY

1) Replace the motor into its location between the 4 half-inch posts

on the right side of the fountain. Gently push down to engage

the suction cups. (Fig. 3a & 3b)

2) Thread the plug through the opening in the back left corner of

the bowl piece (Fig. 3c). Next, thread the cord along the back of

the fountain to the cord notch (Fig. 3d). Use this pass-through to

keep the cord from showing.

3) Line up the lter housing unit over the motor and then the bowl.

You will want to line up the intake tube to t directly into the

motor. Once in place, gently push down, locking the lter hous-

ing into place.

4) Replace the pre-lter over the ow

control knob by sliding the narrow end

in rst. The lip on the top of the pre-lter

will be facing the front of the fountain,

push down to snap it into place over the

ow control knob. (Fig. 3e)

5) Replace the lter and housing lid.

Fig. 3a Fig. 3b

Fig. 3c Fig. 3d

Cord Notch

Opening

Fig. 3e

1 2 ... 63 64 65 66 67 68 69 70 71 72 73

Sem comentários

Petsafe Drinkwell Mini Manual do Utilizador Página 68